Model upgrade using YAPYMDLCHG and get YCHGMDLH@C

Products

• CA 2E

Issue/Introduction

When running the YAPYMDLCHG command, receive an error referencing YCHGMDLH@C                        

YAPYMDLCHG 40 16/05/19 14:01:13.964039 YCHGMDLH@C Y2SY *STMT QCMD From module . . . . . . . . : YCHGMDLH@C
From procedure . . . . . . : YCHGMDLH@C
Statement . . . . . . . . . : 44200 Message . . . . : Previous conversion of Model XXXXXX not completed CAUSE: A previous execution of YAPYMDLCHG for model XXXXXX failed to complete, so model contains work files whose names begin with 'Z'. RECOVERY: (1) Determine cause of failure and correct error. Consult customer support if uncertain. (2) Restore model from a backup and re-run YAPYMDL command.

Environment

CA 2E

All versions

Resolution

For this error, look in the 2E model and look for files starting with 'Z'.

If any 'Z' are found, do the following:

1.  Check if the file(s) is empty.  If so, then delete the file(s).
2.  Check if there are any dependent files.  If so, check if you delete the dependency and the corresponding 'Z' file. 
3.  Rerun the YAPYMDLCHG command

If you require additional assistance, please contact Broadcom Support.