ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

A CEM rule stating account=STC is firing when changes are made to NDT.

book

Article ID: 131868

calendar_today

Updated On:

Products

Compliance Event Manager

Issue/Introduction

A rule to capture administration changes to account=STC is firing when changes are made to NDT, and it should not. 

Cause

'Account' is not valid for the Other Administration events. Instead, Infostorage Key equals STC should be
specified when defining the policy.

Environment

CEM 6.0 plus available maint.  Also TSS ptf SO06888

Resolution

 Modifying the policy from 'Condition = ACCOUNT="STC" ' to Condition = KEY=*"STC" proved corrective.