ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Requirement to check the status of alerts Active or Non-Active
Article ID: 131426
Updated On:
Products
CA Application Performance Management Agent (APM / Wily / Introscope)
INTROSCOPE
Issue/Introduction
Alerts status as "Active" and "Disable"
Are there ways to see the alerts are active or non-active?
Are there ways to see the alerts are active or non-active?
Environment
CA APM 10.7
Resolution
Consider using APM Command Line Workstation to create a report on active alerts.
See below Guide and Community post.
https://docops.ca.com/ca-apm/10-5/en/using/apm-command-line-workstation/clw-command-reference#CLWCommandReference-ActivateAlerts
http://https://communities.ca.com/message/242140078-re-clw-commands?commentID=242140078&et=watches.email.thread
See below Guide and Community post.
https://docops.ca.com/ca-apm/10-5/en/using/apm-command-line-workstation/clw-command-reference#CLWCommandReference-ActivateAlerts
http://https://communities.ca.com/message/242140078-re-clw-commands?commentID=242140078&et=watches.email.thread
Feedback
Yes
No
Powered by
