If the Status Report Name field contains a default value and is Auto-Numbering enabled, the Classic UI follows the Auto-Numbering pattern, while the Modern UX takes the Default value

Article Id: 131380

Status: Published

Updated On: 03-06-2019 06:12

Products:

CLARITY PPM FOR ITG , Clarity PPM On Premise , CLARITY PPM FEDERAL , Clarity PPM SaaS , Clarity PPM SaaS - Application , Clarity PPM SaaS - Application , Clarity PPM On Premise

Issue/Introduction:

STEPS TO REPRODUCE

1. Go to Studio > Objects > Status Report object
2. Go to the attributes list
3. Edit the Name field.
4. Set a default value: MyStatusrpt
5. Go to the Auto-Numbering tab
6. Enable it and set any pattern. Example SR00001
7. Go to the Classic UI
8. Edit a project and go to the Status Report subobject
9. Create a Status Report
10. The name attribute takes the Auto-Numbering pattern SR00001
11. Go to the new UX and open the same project
12. On the Status Report tab, click on the plus sign to create a new Status Report
13. The Status Report is created.

Expected Results: The Status Report name gets the Auto-Numbering pattern as SR00002
Actual Results: The Status Report name gets the default value of MyStatusrpt

Cause:

This is caused by DE48792

Environment:

Release: CODSFF99100-15.6-PPM SAAS-Full Function User
Component:

Resolution:

This is fixed in 15.7