CEMCCONF job fails with the error RC=0730 missing @CEMR_PROC@ symbol
book
Article ID: 131345
calendar_today
Updated On:
Products
Compliance Event Manager
Issue/Introduction
The CEMCCONF customization job fails with RC=0730. The STDOUT shows the problem being "symbols not substituted" for @CEMR_PROC@. However, the @CEMR_PROC@ parameter is not found in the CONFIG.DATA file.
Environment
Release: Component: CEVM
Cause
Bug.
Resolution
The manual circumvention to this failure is to add the line //SET CEMR_PROC='CEMRTIME' in the ..CONFIG.DATA file, and then re-run the CEMCCONF job. The formal prevention is to apply the CEM published solution SO08023.