Risk Rating is not not changing according to the Risk Factors
Article ID: 131292
Updated On:
Products
CLARITY PPM FOR ITG
CLARITY PPM FEDERAL
Clarity PPM SaaS - Application
Clarity PPM On Premise
Issue/Introduction
Risk Rating is not not changing according to the Risk Factors
1. Open a Project
2. Go to Properties Risk Ratings
3. Change the Risk Factors
4. The Risk Rating stays white.
1. Open a Project
2. Go to Properties Risk Ratings
3. Change the Risk Factors
4. The Risk Rating stays white.
Cause
This is cause by Risk Factors in the Build Weighted Average Formula that are not in the Project View
Environment
Clarity PPM 15.6
Resolution
1. Make note of the Risk Factors in the Project Properties >>Risk Rating
2. Go to Administration>>Object>>Project Object
3. Click Attributes tab
4. Search for Risk attribute
5. Click on the Formula - Build Weighted Average Formula
6. Remove any items that are not listed in the Risk Factors
2. Go to Administration>>Object>>Project Object
3. Click Attributes tab
4. Search for Risk attribute
5. Click on the Formula - Build Weighted Average Formula
6. Remove any items that are not listed in the Risk Factors
Feedback
Powered by
