Datacom OAM DB02817E and IGD17061I INSUFFICIENT SECURITY

Products

• Datacom
• Datacom/AD
• Datacom/DB

Issue/Introduction

What is causing Datacom Online Area Move (OAM) to fail with DB02817E messages with ERROR RENAME and ERROR CLOSE DISPOSITION 13(11)?

This was accompanied by IEC331I 042-002(04100800) and IGD17061I INSUFFICIENT SECURITY AUTHORIZATION 
 

Environment

Release : all

Component : Datacom/DB

Component : Datacom/AD

Resolution

Datacom Online Area Move (OAM) encountered an error during the process of the internal close rename/delete handling.

Per CA Datacom Core - 15.1 section "Perform an Online Area Move for Index and Data Areas" topic "Review Limitations and Restrictions":

The security ID associated with the MUF region must have authority (security) to support data set alter, data set renames, and data set deletes.

Each MUF instance that is externally secured would need to make sure each MUF instance has these security rights to control the datasets owned by the MUF instance.

Additional Information

In the case noted, the following messages were seen in the Datacom MUF jeslog:

DB02817E - ONLINE_AREA_MOVE 300 G10 ERROR RENAME RC=00000008 
DB02817E - ONLINE_AREA_MOVE 300 G10 ERROR RENAME VOLSER vvvvvv 
DB02405I - PXX START ***MOVDS 0 PATCH ONLAM-300-G10 D-1 CONSOLE ON 
DB02406I - PXX END - PATCH COM 8014 
DB02817E - ONLINE_AREA_MOVE 300 G10 ERROR CLOSE DISPOSITION 13(11) 
   ...  along with ...
IEC331I 042-002(04100800),mufname ,stepname ,RNAM,IGG0CLH2         
IEC331I VOL,vvvvvv,NAME,appldsn.DB300.G10                       
IGD17061I INSUFFICIENT SECURITY AUTHORIZATION FOR  571            
DATA SET appldsn.DB300.G10                                      
ON VOLUME vvvvvv HISTORIC RETURN CODE IS 8                        
DIAGNOSTIC INFORMATION IS 04100800                                
IEC614I RENAME FAILED - RC 008, DIAGNOSTIC INFORMATION IS (04100800)