ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

UMP Can I put an ip list in the discovery wizard


Article ID: 130881


Updated On:


DX Unified Infrastructure Management (Nimsoft / UIM) NIMSOFT PROBES


I need to enter a series of ip's. Is there a way of entering a list ?


Component: UIMUMP


If you select the New Range Scope then just to right of where you would add a single ip there should be a small box with a down arrow on it. If you click that then that opens a dialog box. You can paste multiple ip's into that box (one ip per line). Clicking OK should then fill out 1 line per entry.