How to show the status of CA Disk's auto-restore activity
book
Article ID: 130355
calendar_today
Updated On:
Products
Disk Backup and Restore - MVSDISK BACKUP AND RESTORE- ADD-ON OPTIODISK BACKUP AND RESTORE
Issue/Introduction
No auto restores are being performed. Is there any command that will show the status of CA Disk's auto-restore activity, if it is being used/active?
Environment
Release: Component: DISKOS
Resolution
You can check if the CA Disk catalog management hook and DFHSM SVC hook are installed for the CA Disk Auto-Restore Function by issuing the operator command: S DMSAR,DMSAR=STATUS
The catalog management hook and DFHSM SVC hook of CA Disk are installed with the following command: S DMSAR,DMSAR=INSTALL See also chapter "Install the Auto-Restore Function" at link - https://docops.ca.com/ca-disk-backup-and-restore/12-5/en/installing/configure-your-product/customization-options/the-auto-restore-function/install-the-auto-restore-function
If the Vantage Auto-Restore Manager (ARM) is used to manage the DMSAR activity, then can check with command F SAMS,ARM,START if the Vantage Auto-Restore Manager is already started.