How to show if CA Disk's Auto-Restore Function is active.

Products

• Disk Backup and Restore - MVS
• DISK BACKUP AND RESTORE- ADD-ON OPTIO
• DISK BACKUP AND RESTORE

Issue/Introduction

No auto restores are being performed.
Is there any command that will show the status CA Disk catalog management hook and DFHSM SVC hook that is required for the CA Disk Auto-Restore Function

Environment

Release:
Component: DISKOS

Resolution

Check if the CA Disk catalog management hook and DFHSM SVC hook are installed for the CA Disk Auto-Restore Function by issuing the operator command:
S DMSAR,DMSAR=STATUS

The catalog management hook and DFHSM SVC hook of CA Disk are installed with the following command:
S DMSAR,DMSAR=INSTALL
See also chapter "Install the Auto-Restore Function" at link -
https://techdocs.broadcom.com/us/en/ca-mainframe-software/performance-and-storage/ca-disk-backup-and-restore/14-0/installing/configure-your-product/customization-options/the-auto-restore-function/install-the-auto-restore-function.html

If the Vantage Auto-Restore Manager (ARM) is used to manage the DMSAR activity, then can check with command
F SAMS,ARM,START
if the Vantage Auto-Restore Manager is already started.