2E Z from file to function error MCH3601 pointer not set for location referenced

Products

• CA 2E

Issue/Introduction

When we use "F" to view the functions over that file or "Z" to zoom to the access paths, get error MCH3601 - Pointer not set for location referenced. Joblog displays is:

Message ID . . . . . . : MCH3601
Severity . . . . . . . : 40
Message type . . . . . : Diagnostic 
Message . . . . : Pointer not set for location referenced.
Cause . . . . . : A pointer was used, either directly or as a basing pointer, that has not been set to an address.

Environment

CA 2E 8.7 and higher

Resolution

Based on the MCH3601 pointer not set error provide,  it is likely that the model's Object Table User Space needs to be rebuilt.  To do this perform the following: 

1.  Ensure no one is using the model
2.  YDLTOBJTBL
3.  YEDTDTAARA YSNCMDLRFA, change value to N
4.  YSNCMDL
5.  Edit the model and see if you can Z into the files function/access path now.

 

If step5 still fails, please contact Broadcom Support.