book
Article ID: 129693
calendar_today
Updated On:
Issue/Introduction
The client has a single report that shows a location of PDSK.
How can they change the location from PDSK to PERM?
Resolution
The View report location of PDSK means that a report is on primary disk and "possibly" tape.
If, upon review thereof, the report is not on tape, then a View backup will be the only way to get it to tape.
For that, use the following procedure:
. Run SARBCH, with the following /CHANGE card, to reset the report's backup switch:
/CHANGE ID=xxxxxxxxxxxx GEN=nnnnn SEQ=nnnnn BACKUP=OFF
. Set SARINIT EROPRO=ALL or EROPRO=YES.
. Run a View backup, using "/F sarstc,NEW".
After the backup, the Location of the report should then be PERM.
The client will change their ERO entry to: /* ALL DRETPD=0 and RETPD=32767.