ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Informatica error on getworkflowlog
Article ID: 129594
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
The RA Informatica job finishes without any error message. Also the session and workflowlogs are transferred.
Within Informatica this error message is shown:
[ICMD_10033] Command [getWorkflowLog] failed with error [CCM_10541] Internal error. Failed to create a client for service [/coreservices/DomainService] [DTF_0020] The [UserManagementService] Service failed to authenticate the user with the error message [[UM_10112] The Service Manager cannot authenticate the user because the password is blank. Provide a valid password for the user.].
Within Informatica this error message is shown:
[ICMD_10033] Command [getWorkflowLog] failed with error [CCM_10541] Internal error. Failed to create a client for service [/coreservices/DomainService] [DTF_0020] The [UserManagementService] Service failed to authenticate the user with the error message [[UM_10112] The Service Manager cannot authenticate the user because the password is blank. Provide a valid password for the user.].
Environment
AIX
Resolution
This can be fixed by setting these three environment variables.
INFA_DEFAULT_DOMAIN_USER
INFA_DEFAULT_DOMAIN_PASSWORD
INFA_DEFAULT_SECURITY_DOMAIN
INFA_DEFAULT_DOMAIN_USER
INFA_DEFAULT_DOMAIN_PASSWORD
INFA_DEFAULT_SECURITY_DOMAIN
Feedback
Yes
No
Powered by
