Service Manager binds to IPv6 address only
search cancel

Service Manager binds to IPv6 address only

book

Article ID: 129023

calendar_today

Updated On:

Products

CA Automic Workload Automation - Automation Engine

Issue/Introduction

The Service Manager is only binding to the IPv6 address.
According to the documentation, the system runs either in IPv4/IPv6 only environment, or a dual-stack environment where both is allowed.

Environment

Release:
Component: AAUTEN

Resolution

To obtain the correction for this issue please install one of the following versions or higher:

  • Automation Engine 12.1.5 - Available 
  • Automation Engine 12.2.2 - Available
  • Automation Engine 12.3.0 - Available 


All of the dates above are tentatively planned and are subject to change.
 

Powered by Wolken Software