Ouput of /DIS OLDS IMS command in batch mode
Article ID: 128835
Updated On:
Products
SYSVIEW Performance Management
NXBRIDGE - SYSVIEW/ENDEVOR
Issue/Introduction
Not able to capture the ouput of /DIS OLDS IMS command ouput in batch mode.
Environment
Release:
Component: SYSVW
Component: SYSVW
Resolution
The reason you are not seeing the same output for both commands is because the response from both commands is different.
It appears that when a reply is used to issue the /DIS OLDS IMS command, the system responds with a confirmation message of the reply message and then responds with the rest of the data
The IEE600I message was of Type NR, meaning it is a single line response message.
Since it's only a single line response, the only response we will show on the XMVS command is that single line
It appears that when a reply is used to issue the /DIS OLDS IMS command, the system responds with a confirmation message of the reply message and then responds with the rest of the data
The IEE600I message was of Type NR, meaning it is a single line response message.
Since it's only a single line response, the only response we will show on the XMVS command is that single line
Feedback
Yes
No
Powered by
