Is it possible to use REST API to run the CLI command update action activate watch Watch ID mh Model Handle

Article Id: 128593

Status: Published

Updated On: 09-04-2019 05:52

Products:

CA Spectrum , CA Spectrum , CA Spectrum , CA Spectrum

Issue/Introduction:

Tech doc to advise it is not possible to use REST API to run the CLI command update action=activate watch=<Watch_ID> mh=<Model_Handle>

Is it possible to use REST API to run the CLI command update action=activate watch=<Watch_ID> mh=<Model_Handle>

Environment:

Release: MSPSPD99000-10.3-Spectrum-Device Based Suite-MSP
Component:

Resolution:

As of Spectrum 10.3.1 it is not possible to use REST API to run the command normally run from CLI:
update action=activate watch=<Watch_ID> mh=<Model_Handle>