ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
WORKLOAD AUTOMATION ESP to schedule JES2 Command
Article ID: 128590
Updated On:
Products
ESP Workload Automation
Issue/Introduction
WORKLOAD AUTOMATION ESP to schedule JES2 Command
Environment
Release:
Component: ESPWA
Component: ESPWA
Resolution
You can use the VS command. The VS command is used to issue a command to the operating system.
For your example:
Issue a JES2 command In the following example, initiators 1 through 10 are started at 6 am daily.
EVENT ID(CYBER.INIT_START) SCHEDULE 6AM DAILY VS '$SI1-10' ENDDEF
For your example:
Issue a JES2 command In the following example, initiators 1 through 10 are started at 6 am daily.
EVENT ID(CYBER.INIT_START) SCHEDULE 6AM DAILY VS '$SI1-10' ENDDEF
Additional Information
Feedback
Yes
No
Powered by
