Getting an error when try to deploy a package to some hosts
Article ID: 127986
Updated On:
Products
DX Infrastructure Management
NIMSOFT PROBES
Issue/Introduction
I am trying to deploy an update to a <PROBE> via a package but keep getting an error.
The probe and robot etc seems to be running fine but when trying to deploy via Admin Console I get this error:
(1) error, Received status (1) on response (for sendRcv) for cmd = 'inst_pkg'.
When I look at the controller.log it shows the below msg :
Feb 14 22:37:26:970 [140455139911424] Controller: inst_pkg - Unable to write file content to robot/pkg/ready/!logmon_linux_lvm.pkg
I have deployed the package to about 2000 host and it was successful.
Just having issues with 10 of them.
What could be the problem?
The probe and robot etc seems to be running fine but when trying to deploy via Admin Console I get this error:
(1) error, Received status (1) on response (for sendRcv) for cmd = 'inst_pkg'.
When I look at the controller.log it shows the below msg :
Feb 14 22:37:26:970 [140455139911424] Controller: inst_pkg - Unable to write file content to robot/pkg/ready/!logmon_linux_lvm.pkg
I have deployed the package to about 2000 host and it was successful.
Just having issues with 10 of them.
What could be the problem?
Cause
the Nimsoft drive was full in this case /opt
Environment
UIM 9.X and earlier
ADE 9.X and earlier
ADE 9.X and earlier
Resolution
Free up space on the Nimsoft partition to allow for proper installation.
Feedback
Yes
No
Powered by
