How to Create a CA Deliver Database

Products

• OM Deliver
• OM View

Issue/Introduction

This article tells of how to create a CA Deliver database.

Environment

CA Deliver - All Releases

Resolution

The following RMODBASE job is used to create a Deliver database: 

//XXXXXXXX JOB ... 
//RMODBASE EXEC PGM=RMODBASE,PARM='dlvr_hlq' <=== Modify DB name 
//STEPLIB DD DISP=SHR,DSN=DLVR.CVDELOAD <=== Modify, if used 
//SYSPRINT DD SYSOUT=* 
//SYSIN DD * 
ADDDS UNIT=3390 CYLINDER=nnnn BLKSIZE=13904 VOLSER=xxxxxx 
ADDDS UNIT=3390 CYLINDER=nnnn BLKSIZE=13904 VOLSER=xxxxxx 
MAKECKPT UNIT=3390 CYLINDER=100 VOLSER=xxxxxx EMPTY 
/* 
// 

 Note: There needs to be an ADDDS statement for each data extent to be allocated.

Modify the CVDEPENU(RMOLJCLB) member, addressing the //STEPLIB statement, addressing the //STEPLIB statement. 

Either use //STEPLIB ith a defined CVDELOAD library, or comment it out or remove it, if the library will be defined in the linklist. 


Run RMODBASE OLOAD: 

//XXXXXXXX JOB ... 
//RMODBASE EXEC PGM=RMODBASE,PARM='dlvr_hlq' <=== Modify DB name 
//STEPLIB DD DISP=SHR,DSN=DLVR.CVDELOAD <=== Modify, if used 
//SYSPRINT DD SYSOUT=* 
//RMOOLIB DD DISP=SHR,DSN=dlvr_hlq.CVDEPENU 
//SYSIN DD * 
OLOAD 
/* 
// 

Run RMODBASE BLOAD: 

//XXXXXXXX JOB ... 
//RMODBASE EXEC PGM=RMODBASE,PARM='dlvr_hlq' <=== Modify DB name 
//STEPLIB DD DISP=SHR,DSN=DLVR.CVDELOAD <=== Modify, if used 
//SYSPRINT DD SYSOUT=* 
//RMOBLIB DD DISP=SHR,DSN=dlvr_hlq.CVDED133 
//SYSIN DD * 
BLOAD 
/* 
//