How to reset UIM Virtual Sync
Article ID: 127198
Updated On:
Products
CA Spectrum
Issue/Introduction
How to reset the UIM Integration Virtual Sync, without removing models.
Environment
Release:
Component: SPCOCK
Component: SPCOCK
Resolution
1. In OneClick console, observe the values of the below attributes
Virtual_Sync_Status 0x633001b
Next_Virtual_Sync_Time 0x6330016
Last_Virtual_Sync_Time 0x6330015
Nimsoft_Virtualization_Enabled 0x6330014
2. In Spectrum Administration UIM configuration page, unselect "VMware Management" and Save without choosing to delete the UIM models
Verify value of the above attributes as below.
By this we can confirm that virtual integration is disabled and Virtual_Sync_Status is 0 (NOTSCHEDULED).
Last_Virtual_Sync_Time 0x6330015
Next_Virtual_Sync_Time 0x6330016
Nimsoft_Virtualization_Enabled 0x6330014 No
Virtual_Sync_Status 0x633001b 0
Below is the mapping of Virtual_Sync_Status attribute value:
0 =) NOTSCHEDULED
1 =) RUNNING
2 =) SCHEDULED
3 =) DCMIGRATING
3. Wait for few minutes and then select "VMware Management" in Spectrum Administration UIM configuration page and Save.
Verify value of the above attributes.
Nimsoft_Virtualization_Enabled value should be Yes and Virtual_Sync_Status will be initially 1 (RUNNING), once virtual sync is complete its value will be 2 (SCHEDULED) with virtual sync scheduled. Last_Virtual_Sync_Time and Next_Virtual_Sync_Time will have proper sync time.
Virtual_Sync_Status 0x633001b
Next_Virtual_Sync_Time 0x6330016
Last_Virtual_Sync_Time 0x6330015
Nimsoft_Virtualization_Enabled 0x6330014
2. In Spectrum Administration UIM configuration page, unselect "VMware Management" and Save without choosing to delete the UIM models
Verify value of the above attributes as below.
By this we can confirm that virtual integration is disabled and Virtual_Sync_Status is 0 (NOTSCHEDULED).
Last_Virtual_Sync_Time 0x6330015
Next_Virtual_Sync_Time 0x6330016
Nimsoft_Virtualization_Enabled 0x6330014 No
Virtual_Sync_Status 0x633001b 0
Below is the mapping of Virtual_Sync_Status attribute value:
0 =) NOTSCHEDULED
1 =) RUNNING
2 =) SCHEDULED
3 =) DCMIGRATING
3. Wait for few minutes and then select "VMware Management" in Spectrum Administration UIM configuration page and Save.
Verify value of the above attributes.
Nimsoft_Virtualization_Enabled value should be Yes and Virtual_Sync_Status will be initially 1 (RUNNING), once virtual sync is complete its value will be 2 (SCHEDULED) with virtual sync scheduled. Last_Virtual_Sync_Time and Next_Virtual_Sync_Time will have proper sync time.
Feedback
Yes
No
Powered by
