Cust had already downloaded NM 12.2 pax files from CA's support website
and got through all the process of installation using Install Utility till
the point to run I01ALLOC job to allocate the libraries.
Cust could not move forward (running I03RCSMP) since job I02INSMP was
not generated (to run before I03RCSMP).
This was sent to cust:
The following text (entered by a colleague) is from an issue from years ago
and it resolved that problem:
I found another issue where a customer had the same problem as you. In
that issue the customer went back into the INSTALL exec then selected
option 2 to install products and then selected option 2 again to
After doing so the I02INSMP job appeared.
Cust replied to us: When I regenerated the JCL I got the I02INSMP job.
So the method you suggested worked successfully.