CAL2XC25W WARNING! COUPLING FACILITY NO LONGER SUPPORTED.
Article ID: 127077
Updated On:
Products
CA 7 Workload Automation
Issue/Introduction
How do I stop the following warning message from coming out of the ICOM started task?
CAL2XC25W WARNING! COUPLING FACILITY NO LONGER SUPPORTED.
Environment
Release:
Component: 7
Resolution
Starting with CA 7 r11.3, the coupling facility of ICOM is no longer supported. To eliminate this informational WTO requires changing the ICOM execution parameter to remove the CF=N parameter and any &CF reference that exist on the EXEC statement as well.
Feedback
Yes
No
Powered by
