Is there any way in RAPS to do an auto-refresh on the screens?
book
Article ID: 127033
calendar_today
Updated On:
Products
CA CISCA Common Services for z/OSCA 90s ServicesCA Database Management Solutions for DB2 for z/OSCA Common Product Services ComponentCA Common ServicesCA Datacom/ADCA ecoMeter Server Component FOCCA Easytrieve Report Generator for Common ServicesCA Infocai MaintenanceCA IPCUnicenter CA-JCLCheck Common ComponentCA Mainframe VM Product ManagerCA Chorus Software ManagerCA On Demand PortalCA Service Desk Manager - Unified Self ServiceCA PAM Client for Linux for zSeriesCA Mainframe Connector for Linux on System zCA Graphical Management InterfaceCA Web Administrator for Top SecretCA CA- XpertwareCA VollieDEVELOPMENT ENVIRONMENT
Issue/Introduction
Is there any way in RAPS to do an auto-refresh on the screens such as RAPS-1010 RDR Que display?
Environment
z/VSE any level RAPS for VSE any release
Resolution
See CIS Admin Guide page 2-70
SET AUTOREFRESH SET AUTOREFRESH puts the current session into autorefresh mode, automatically redisplaying the current CAICUI panel with updated information at specified intervals. CAICUI commands may be used in the usual way during a session that is in autorefresh mode. This command may be issued from any panel.
To cancel autorefresh mode during a CUI session, press [Clear] or any PA key. Type: global SET AUTORefresh hhmmss
hhmmss Specify the time interval after which the current CAICUI panel is to be automatically redisplayed. The minimum interval that may be specified is five seconds. This operand will be right justified and left filled with zeroes. Note: SET AUTOREFRESH may not be used in ICCF or in any CAICUI session that uses the CAICUI transaction interface CACCTLNK.
To put the current CAICUI session into autorefresh mode, updating the current panel every 30 seconds, use the following command: SET AUTOR 30
Additional Information
See CIS Admin Guide page 2-70 https://docops.ca.com/bookshelves/ca-cis