Performed CA7 SHUTDOWN, Z1 . But failed (see messages below) because there were multiple batch terminal interfaces running.
Had to cancel CA7 started task.
/SHUTDOWN,Z1
SCM2-11 BATCH RUN IN PROGRESS. /SHUTDOWN IGNORED.
Should we change our automated shutdown procedure from a SHUTDOWN,Z1 to a SHUTDOWN,Z3 and if so,
what happens to the batch runs in progress in CA7?
Release:
Component: 7
If you change your shutdown procedure for CA7 from a SHUTDOWN,Z1 to a SHUTDOWN,Z3. Z3 will cause CA7 to shutdown immediately even if online and/or batch type terminals are active and in use, it will terminate with a RC=8.
Z2 Z3 Z4 ** Option only valid for CA 7 r11.3 and earlier releases. Z5 ** Option only valid for CA 7 r11.3 and earlier releases. |
|||
Case Reason | Answer - Available |