Is it possile to use REST API to run the CLI command show watch mh ModelHandle
book
Article ID: 126398
calendar_today
Updated On:
Products
CA Spectrum
Issue/Introduction
Tech doc to advise it is not possible to use REST API to run the CLI command show watch mh=<Model_Handle>
Is it possible to use REST API to run the CLI command show watch mh=<Model_Handle>
Environment
Release: MSPSPD99000-10.3-Spectrum-Device Based Suite-MSP
Component:
Resolution
As of Spectrum 10.3.1 it is not possible to use REST API to run the command normally run from CLI:
show watch mh=<Model_Handle>
Feedback