SMP/E APPLY CHECK job fails during link-edit processing with GIM23911E and return code 08

Article Id: 125288
Status: Published
Updated On: 11-02-2019 09:50
Products:
CA RC/Migrator , CA Endevor SCM Interface , DB2 Administration , CA RC Compare for DB2 for z/OS , CA RC Extract for DB2 for z/OS , CA RC/Query , CA RC Secure for DB2 for z/OS , CA RC Update for DB2 for z/OS , CA Database Analyzer for DB2 for z/OS , CA Fast Unload for DB2 for z/OS , CA Fast Check for DB2 for z/OS , CA Fast Index for DB2 for z/OS , CA Fast Load for DB2 for z/OS , CA Rapid Reorg for DB2 for z/OS
Issue/Introduction:

Executing SMP/e Apply to apply maintenance and receiving link-edit processing errors.

GIM23911E LINK-EDIT PROCESSING FOR SYSMOD sysmod FAILED FOR MODULE modname IN LMOD loadmod IN THE library LIBRARY. THE RETURN CODE (rtncode) EXCEEDED THE ALLOWABLE VALUE. DATE yy.ddd - TIME hh:mm:ss - SEQUENCE NUMBER seqno - SYSPRINT FILE sysprint.                                                   
IEW2456E   SYMBOL symbol UNRESOLVED. MEMBER COULD NOT BE INCLUDED FROM THE DESIGNATED CALL LIBRARY. [NAME SPACE = name-space]                        

Reviewing the DDDEFs all libraries are correctly defined.

What could be causing the link-edit processing errors?

Cause:

If all checks out correctly then review the job output for possible space errors; for example GIM26701S.

Environment:

Release:
Component: INS

Resolution:

An example of a space error causing link-edit processing errors is GIM26701S.

GIM26701S    DIRECTORY SPACE FOR THE library LIBRARY WAS EXCEEDED DURING AN ATTEMPT TO STORE enttype ENTRY entname.          

In this particular case, increase the directory block allocations in the SMPWRKn DD file definitions in the JCL and run the Apply Check again.