Conversion of RMF to Pattern masking

Article Id: 125246

Status: Published

Updated On: 24-01-2019 12:28

Products:

CA TLMS Tape Management

Issue/Introduction:

Getting the following error message during RMF conversion.
0001 CONVERT

CAT3312I RMF CONVERSION STARTED

CAT3395E - PUT ERROR FOR THE RMF R15 = 008 ERRORS = 008

CAT3397I KEY(BOB.PC0123.TAPED.- * )

CAT3395E - PUT ERROR FOR THE RMF R15 = 008 ERRORS = 008

CAT3397I KEY(BOB.PC0987.ROLL.- * )

CAT3395E - PUT ERROR FOR THE RMF R15 = 008 ERRORS = 008

CAT3397I KEY(PIG.SORTED.- * )

CAT3395E - PUT ERROR FOR THE RMF R15 = 008 ERRORS = 008

CAT3397I KEY(PIG.BACKUP.- * )

CAT3313I RMF CONVERSION COMPLETE

CAT3308I END OF RMF UPDATE REPORT RC = 08

Environment:

TLMS 12.6/14.0.

Resolution:

This is from duplicate DSN entries. This was from a previous release of TLMS that didn't check for duplicates. Remove the duplicate RMF entries via PROC CTAPPROC(CATRMFU). Rerun the CONVERT job after clean up.