Event-Scans of zOS-Console fail after Updates
Article ID: 125072
Updated On:
Products
CA Automic Workload Automation - Automation Engine
AUTOMIC WORKLOAD AUTOMATION
Issue/Introduction
After upgrading to a new version of the z/OS agent, all Event-Scans of z/OS-Console fail. these two errors can be found in the log:
fwrite error. error=65(EDC5065I A write system error was detected.)
get_record <-- (errorflocate: 59-EDC5059I An attempt to reposition a VSAM file failed.)
get_record <-- (errorflocate: 59-EDC5059I An attempt to reposition a VSAM file failed.)
Environment
Release:
Component: AAUTEN
Component: AAUTEN
Resolution
Solution: Re-initialization of UCEVENT VSAM
The file must contain at least one dummy record. Therefore, repeat the initialization steps. The name UC4Q.UCEVENT.VSAM.V11 is here an example. Take the name from your system's UCEVENT VSAM.
To check content of VSAM please submit this jobstep:
The file must contain at least one dummy record. Therefore, repeat the initialization steps. The name UC4Q.UCEVENT.VSAM.V11 is here an example. Take the name from your system's UCEVENT VSAM.
//INITVSAM EXEC PGM=IDCAMS
//SYSPRINT DD SYSOUT=*
//OUT1 DD DISP=SHR,DSN=UC4Q.UCEVENT.VSAM.V11
//SYSIN DD *
REPRO INFILE(IN1) OFILE(OUT1)
//IN1 DD *
DUMMY
/*
//SYSPRINT DD SYSOUT=*
//OUT1 DD DISP=SHR,DSN=UC4Q.UCEVENT.VSAM.V11
//SYSIN DD *
REPRO INFILE(IN1) OFILE(OUT1)
//IN1 DD *
DUMMY
/*
To check content of VSAM please submit this jobstep:
//INITVSAM EXEC PGM=IDCAMS
//SYSPRINT DD SYSOUT=*
//OUT1 DD DISP=SHR,DSN=UC4Q.UCEVENT.VSAM.V11
//SYSIN DD *
PARM GRAPHICS(CHAIN(SN))
PRINT INFILE(OUT1)
/*
//SYSPRINT DD SYSOUT=*
//OUT1 DD DISP=SHR,DSN=UC4Q.UCEVENT.VSAM.V11
//SYSIN DD *
PARM GRAPHICS(CHAIN(SN))
PRINT INFILE(OUT1)
/*
Feedback
Powered by
