Sysview deploy with CSM is missing CFGE100D XML member

book

Article ID: 124923

calendar_today

Updated On:

Products

CA SYSVIEW Performance Management NXBRIDGE - SYSYVIEW/ENDEVOR

Issue/Introduction

Setting up deployment for SYSVIEW r15.0 in CSM you get the error message:

Unable to locate 'MAINT.SYSV.R150.CFGEXML(CFGE100D)'

You see these members in MAINT.SYSV.R150.CFGEXML
- CAAESXML
- CFGE200A
- CFGE200D
- CFGE200P

When you closer check you see also in member CFGE100 references to members:
- CFGE200D
- CFGE200P



Environment

Release:
Component: SYSVW

Resolution

The problem with the CA Sysview deploy is that MOI is also installed in the same CSI...

When you also check the MOI installation manual it say :
Notes:
• After you complete the installation steps and you execute the CAAELLO job, go to Deploy and Configure CA Mainframe Operational Intelligence.
• You cannot deploy a prior CA CSM installation of the product.

(https://docops.ca.com/ca-mainframe-operational-intelligence/2-0-03/en/installing/install-ca-mainframe-operational-intelligence/install-using-ca-chorus-software-manager)..

To solve the CA Sysview deploy issue, remove FMID CFGE200 and CFGE202 from the Sysview CSI and when needed, install them (MOI) into a separate CSI..