Rename FDS LOG Files
Article ID: 124266
Updated On:
Products
Disk Backup and Restore - MVS
DISK BACKUP AND RESTORE- ADD-ON OPTIO
DISK BACKUP AND RESTORE
Issue/Introduction
The High Level Qualifier for the Files Data Set Log Files should be changed from DMS1 to DMS2..
Is it possible to simply rename the existing the Log Files and and just change the FILOGNAME SYSPARM accordingly or is anything else required like DMSAR=REMOVE/INSTALL?
Environment
Release:
Component: DISKOS
Component: DISKOS
Resolution
Nothing else is required. Just rename the Log files and update the FILOGNAM SYSPARM.
NOTE: the FILOGNAM SYSPARM is not stored in Storage and it is read everytime from the SYSPARMS, when DMSAR or a CA DISK Batch job is running.
For this reason a DMSAR=REMOVE/INSTALL is not necessary.
NOTE: the FILOGNAM SYSPARM is not stored in Storage and it is read everytime from the SYSPARMS, when DMSAR or a CA DISK Batch job is running.
For this reason a DMSAR=REMOVE/INSTALL is not necessary.
Feedback
Yes
No
Powered by
