DYNSTAT; PERCENT OF FILE AVAILABLE showing 0% after catalog disk size was increased.
Article ID: 123038
Updated On: 12-14-2018
Products
Dynam for VSE
Dynam VSE Option
Issue/Introduction
Running CA Dynam/T for zVSE v7.0
We migrated the Production environment's Dynam catalog file to a -27 disk. The activity was successful and we used DYNSTAT to verify the status. However, we are confused by the result.
The 'PERCENT OF FILE AVAILABLE' is 0%.
Why is that?
We compared this to LPAR1's DYNSTAT which we also migrated and LPAR1's PERCENT OF FILE AVAILABLE is 99%.
We migrated the Production environment's Dynam catalog file to a -27 disk. The activity was successful and we used DYNSTAT to verify the status. However, we are confused by the result.
The 'PERCENT OF FILE AVAILABLE' is 0%.
Why is that?
We compared this to LPAR1's DYNSTAT which we also migrated and LPAR1's PERCENT OF FILE AVAILABLE is 99%.
Environment
Release:
Component: DYNTVS
Component: DYNTVS
Resolution
You shouldn't have used FCOPY to copy the catalog from the old DASD to the 3390-27 device.
DYNCAT RESTORE REORG should always be used when moving a Dynam catalog to a new location.
DYNCAT RESTORE REORG should always be used when moving a Dynam catalog to a new location.
Feedback
Yes
No
Powered by
