TSS MODIFY FACILITY(hsm=prft=0006) "temp" vs "perm"

Products

• Top Secret
• Top Secret - LDAP

Issue/Introduction

"TSS0963E Shared Profile Table > 65% Full" message, the command "TSS MODIFY FACILITY(HSM=PRFT=0006)" was executed on a "test" LPAR. How can the change be made for a permanent update?

Environment

Release:
Component: TSSMVS

Resolution

If the facility definitions are on the CA Top Secret security file, the TSS MODIFY FACILITY(HSM=PRFT=0006) will update the security file with the change. Nothing else is needed. If the facility definitions are in the CA Top Secret parameter file, to make the change permanent, add the following statement to the CA Top Secret parameter file: FACILITY(HSM=PRFT=0006) If there is already a FACILITY(HSM=PRFT=nnn) statement in the CA Top Secret parameter file, instead of adding the above statement, change the current statement so nnn is 006.