Why are mounted tapes not being AVR'd ?
search cancel

Why are mounted tapes not being AVR'd ?

book

Article ID: 11964

calendar_today

Updated On:

Products

Dynam for VSE Dynam VSE Option

Issue/Introduction

You are wondering why there are tapes that are mounted and available, but not being picked up by AVR

Environment

Release: 7.1
Component: Dynam/D-Disk Management

Resolution

  1. Verify that the TAPE POOL INFORMATION is correct in the DTPOOL option record.
    • This is displayed in Panel CAYD-1220 in CUI --> CA Dynam/T tape drive pool information.

  2. CA Dynam will only perform AVR on drives specified in the Panel. If no drives are specified, all drives will be searched. 

The tape on the unit also must have a recording density that is compatible with the tape drive it is mounted on.