Why are the tunnels not showing up in the interface tab in CA Spectrum OneClick, when the devices have been successfully modeled for Cisco ASA devices?
search cancel

Why are the tunnels not showing up in the interface tab in CA Spectrum OneClick, when the devices have been successfully modeled for Cisco ASA devices?

book

Article ID: 11955

calendar_today

Updated On:

Products

CA Spectrum DX NetOps

Issue/Introduction

Why are the tunnels not showing up in the interface tab in CA Spectrum OneClick, when the devices have been successfully modelled for Cisco ASA devices?

Environment

Release: All Supported Releases
Component: SPCCSS - SpectroSERVER Core

Resolution

In order to model the tunnels in the interface tab, the device must support both Cisco-IpSec-Mib and Cisco-IpSec-Flow-Monitor-mib.

The Cisco ASA devices only support the Cisco-IpSec-Flow-Monitor-mib and due to the lack of Cisco-IpSec-Mib not being populated, CA Spectrum is unable to create the tunnels in OneClick.

If you would like to monitor the tunnels, you can do this via traps as there are traps supported by Cisco-IpSec-Flow-Monitor-Mib.

Additional Information

For further information on mapping traps and creating alarms in Spectrum from mib objects, please refer to this link.

https://docops.ca.com/ca-spectrum/10-3-0/en/managing-network/certifications/managing-mibs-and-traps-with-mib-tools/trap-support-for-mib-objects/