Using LXC Command in ESP
search cancel

Using LXC Command in ESP

book

Article ID: 11927

calendar_today

Updated On:

Products

ESP Workload Automation

Issue/Introduction

I can't enter this command from CSF, how do I use LXC Command from the ESP Workload Automation system?

LXC—Displays the cross-application critical path information for an application. 

Environment

Component: ESP Workload Automation
Release: ALL

Resolution

This command is supported from the Application Monitor panel:
#1 Go to ESP ISPF main menu the option 'A';
#2 Tab down and issue LXC against one application in question.

Example below. go to the application monitor panel and issue an LXC beside the application APPLEND generation 3:
Note: An alternative is to go to page mode and issue the LAPX command.

LAPX APPLEND.3 CRITICAL
CRITICAL PATH JOBS FOR APPLICATION APPLEND.3
1 keeplive IN APPL APPLEND.3 NOT STARTED
2 KEEPAPPL.OPEN IN APPL APPLEND.3 NOT STARTED
3 CYBLZ IN APPL APPLEND.3 IS HELD
3 CRITICAL PATH JOBS FOUND IN 1 APPLICATION
END OF CRITICAL PATH JOBS