Is using REMVOL and ADDVOL control statement for same volsers with TMSXTEND allowed
search cancel

Is using REMVOL and ADDVOL control statement for same volsers with TMSXTEND allowed

book

Article ID: 11892

calendar_today

Updated On:

Products

CA 1 Flexible Storage

Issue/Introduction

Can I do a REMVOL and an ADDVOL for the same range of volsers in one execution of TMSXTEND?  

Resolution

Yes, you can do this and TMSXTEND will complete with RC0, BUT you may not have the result that you wanted.  The REMVOL range will be left in the TMC with all of the old data.  If you are doing this to clear out all of the old data you will need to run this as 2 jobs.  The first job to do the REMVOL, then the second to do the ADDVOL.