Why do I receive SQLCODE -924 when rerunning a Cobol DB2 program with InterTest
Article ID: 117856
Updated On: 10-19-2018
Products
InterTest - CICS
InterTest - Batch
Issue/Introduction
Why do I receive SQLCODE -924 when rerunning a Cobol DB2 program with InterTest in foreground?
If we go back to panel IBCHDB20, we can rerun the program without any problem.
Environment
Release:
Component: INTBAT
Component: INTBAT
Resolution
This is working as designed.
There is a note as follows in chapter "Test IBM DB2 Applications":
"Note: This procedure does not let you end the program and return to the Execution Control panel to retest the same program. You must exit the application and rerun the CLIST (Step 1). ..."
on this page in our documentation:
https://docops.ca.com/ca-intertest-and-ca-symdump/10-0/en/using-batch-tools/batch-debugging/testing-procedures/test-ibm-db2-applications
There is a note as follows in chapter "Test IBM DB2 Applications":
"Note: This procedure does not let you end the program and return to the Execution Control panel to retest the same program. You must exit the application and rerun the CLIST (Step 1). ..."
on this page in our documentation:
https://docops.ca.com/ca-intertest-and-ca-symdump/10-0/en/using-batch-tools/batch-debugging/testing-procedures/test-ibm-db2-applications
Feedback
Was this article helpful?
Yes
No
Powered by
