CA MAT SRB Diagnostic dump - TNEX

Products

• Mainframe Application Tuner

Issue/Introduction

Couple of days repeatedly we are getting the below alerts on our production systems. Could you please assist on it. DUMP.DS.COS1.D180918.T062019.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T122745.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T122805.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T123434.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T123508.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T123510.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T225330.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T233120.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T233125.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T233141.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX DUMP.DS.COS1.D180918.T233146.R06837.FEUPD040 CA MAT SRB Diagnostic dump - TNEX

Environment

Release:
Component: MATUNE

Resolution

What is happening is that 64 bit addressing in IMS control blocks are causing the abends. In CA MAT v11 this isn't available, however it's supported by CA MAT v12. Please try the same monitors in your CA MAT v12 LPAR and see if they are resolved there.