Sysview and CICS NEWCOPY Using Batch

Products

• SYSVIEW Performance Management
• NXBRIDGE - SYSVIEW/ENDEVOR

Issue/Introduction

Is it possible to use SYSVIEW in batch (PGM=GSVXBAT) to submit Newcopy functions? 

Environment

z/OS and CICS

Resolution

Yes and here are two examples of the GSVXBAT (SYSVIEW batch) control cards to be used as input one which uses the CEMT command an one which uses the CICSSET SYSVIEW commands :

Example 1) 

COMMAND=(CICSSET JOB CICS_JOB PROGRAM MBDUMP NEWCOPY)
COMMAND=(END) END THE BATCH SESSION 

Example 2)

COMMAND=(MVS F CICS_JOB,CEMT SET PROG(ProgName)) NEW
COMMAND=(END) END THE BATCH SESSION