After 15.2 Upgrade IConsole display numbers instead of policy name
Article ID: 115667
Updated On:
Products
CA Security Command Center
CA Data Protection (DataMinder)
CA User Activity Reporting
Issue/Introduction
After upgrading to 15.2, we notice that policy column in the iconsole for custom policies contains numbers rather than their actual name.
Environment
Release:
Component: DLPSRV
Component: DLPSRV
Resolution
Even as numbers the Policy will still be coming up fine in standard search.
Check for "ClassName" Column value in "Wgn3ClassificationI18N" table for this particular policy ID i.e 400001.
If the value in "classname" column is blank then it will display the '<PlicyID>'. It may be due to not properly creating the custom Policy.
To make the events policy sync with the events it need to be mapped properly to the below mentioned tables.
The tables involved are:- WGN3STRINGI18N,WGN3CLASSIFICATIONnode,WGN3CLASSIFICATIONI18N,WGN3CLASSIFICATIONBASE,WGN3RESOURCE.
Check for "ClassName" Column value in "Wgn3ClassificationI18N" table for this particular policy ID i.e 400001.
If the value in "classname" column is blank then it will display the '<PlicyID>'. It may be due to not properly creating the custom Policy.
To make the events policy sync with the events it need to be mapped properly to the below mentioned tables.
The tables involved are:- WGN3STRINGI18N,WGN3CLASSIFICATIONnode,WGN3CLASSIFICATIONI18N,WGN3CLASSIFICATIONBASE,WGN3RESOURCE.
Feedback
Yes
No
Powered by
