WCC ECLI - Cannot execute command
Article ID: 115349
Updated On:
Products
CA Workload Automation AE - Scheduler (AutoSys)
Autosys Workload Automation
Issue/Introduction
When using WCC ECLI to execute 'autorep -J ALL',
I got the following error message:
2018-09-19 13:53:17,888 @ecli < Thread-30270> [] ERROR #CommandProcess # Failed to log on using the given credentials. com.ca.uejm.command.client.common.CommandException: Failed to log on using the given credentials.
In EEM / WCC0004, permission is ALLOW for policy CommandExecuteDefault on resource 'server/*' for action 'Execute' # ./uejmver.sh
I got the following error message:
2018-09-19 13:53:17,888 @ecli < Thread-30270> [] ERROR #CommandProcess # Failed to log on using the given credentials. com.ca.uejm.command.client.common.CommandException: Failed to log on using the given credentials.
In EEM / WCC0004, permission is ALLOW for policy CommandExecuteDefault on resource 'server/*' for action 'Execute' # ./uejmver.sh
Environment
Release:
Component: ATSYS
Component: ATSYS
Resolution
Create a credential user thru the Credential tab
1) add user 'autosys' for server 'Autosys_PROD'
2) click on 'Set Active User'
3) click on 'Validate'
1) add user 'autosys' for server 'Autosys_PROD'
2) click on 'Set Active User'
3) click on 'Validate'
Feedback
Yes
No
Powered by
