CA View- How to resolve SARXTD22 messages?
search cancel

CA View- How to resolve SARXTD22 messages?

book

Article ID: 115311

calendar_today

Updated On:

Products

Deliver View

Issue/Introduction



How to resolve SARXTD22 messages?
SARXTD22 ********************************************************* 
SARXTD22 * WARNING: The Automatic Report Archival SVC is already * 
SARXTD22 * active, if restart is being performed to refresh the * 
SARXTD22 * SVC, reply "Y" to the following message, than either * 
SARXTD22 * issue a "F sarxtd,OFF" (if running with NOTERM) or * 
SARXTD22 * "S sarxtd,PARM=OFF" (if the task normally terminates * 
SARXTD22 * after activation), and reissue the start command. * 
SARXTD22 *********************************************************

Environment

Release:
Component: VIEW

Resolution

Generally you need to follow this sequence of commands....
Reply "Y" to the SARXTD01 message then depending on your system choose S SARXTD,PARM=OFF OR F SARXTD,OFF this will stop SARXTD
("F sarxtd,OFF" (if running with NOTERM) or "S sarxtd,PARM=OFF" (if the task normally terminates after activation))
P SARSTC - this will stop SARSTC
S SARXTD - this will start SARXTD
S SARSTC - this will start SARSTC

If the above steps dont resolve it, add a DD statement: in your SARXTD JCL (that should stop the messages)
//NOCONF DD DUMMY