How to disable WLC threshold alerts in Spectrum

Products

• CA Spectrum

Issue/Introduction

How to disable WLC threshold alerts in Spectrum

Environment

Release: Any
Component: SPCOCK

Resolution

There is the following way to change this for the 2 WLC model types, that are supported (Cisco and Aruba).

Cisco:

1. Open the Locater search in the OneClick console
2. Open the section "Application Models"
3. Double-click "All Application Models"
4. Filter in the list for "Cisco_LWAPP_App"
5. You should have the Cisco WLC models, mark all
6. Right-click the marked list -> Utilities -> Attribute Editor
7. Behind "User Defined" click on "add"
8. In the search field filter for "0x1333" and you will see that "0x13339" (maxUploadVolumnePerClient) is the value you were looking for
9. Mark the attribute in the list and "OK"
10. Move the attribute to the right side (with > arrow button)
11. Click in each field to change to "0" and click "Apply"
12. This should give you the list on which it was changed, Just "Close" and "OK" out of the rest.

Note: If you are not sure, you can still use "undo" on all or a few selected

For the Aruba (in case you have those as well), use these same steps as above, just search for "Aruba_Controller_App" under "4." and "5." to filter for and to select.