Enabling ENABLE parm member
Article ID: 113531
Updated On:
Products
RC Compare for DB2 for z/OS
Issue/Introduction
I applied a PTF that required "RCM_INTELLIGENT_REBIND(YES)" to be added to the ENABLE member in CDBAPARM library
I applied a PTF that required "RCM_INTELLIGENT_REBIND(YES)" to be added to the ENABLE member in CDBAPARM library.
In our Lab (sandbox) envt I added this statement to member ENABLE77 and intelligent rebind worked, however when added to ENABLE77 in our Dev envt it didn't work.
My question is how is the ENABLE member picked up?
Is the suffix specified somewhere or does it default to something?
I applied a PTF that required "RCM_INTELLIGENT_REBIND(YES)" to be added to the ENABLE member in CDBAPARM library.
In our Lab (sandbox) envt I added this statement to member ENABLE77 and intelligent rebind worked, however when added to ENABLE77 in our Dev envt it didn't work.
My question is how is the ENABLE member picked up?
Is the suffix specified somewhere or does it default to something?
Environment
z/os DB2
Resolution
The ENABLExx Suffix is controlled by the PTISYSxx member in your CDBAPARM lib The * entry here in mine is set to 00 to it would use ENABLE00 DSNAME=00 SETUP=00 PLANS=00 ISPF=00 *=00
Feedback
Yes
No
Powered by
