SPM TEST HOST CONFIGURATION FAILURE - UNABLE TO PERFORM TEST

Products

• CA Spectrum
• DX NetOps

Issue/Introduction

SPM ICMP test created on OneClick Console does not run on the device. These are the symptoms observed: 

- The test state goes to Disabled. 
- The test status is Device Disabled. 
- The test state is Maintenance 
- When manually run the test, the following message is displayed: 
SPC-OCC-10183: The following error(s) occurred when attempting to run the selected test(s): 
SPC-OCC-11641: Failure. 

After set RW SNMP Community String from RO to RW on the modeled device, the test Status is now Bad Configuration. 

Environment

Release: All Supported Releases

Component: SPCAPP - Applications

Resolution

Deleted and rediscover the Cisco device with Read Write SNMP Community String. As it was previous modeled using Read Only Community String