How to reactivate TPXOPER after it has been quiesced (CA TPX)?
search cancel

How to reactivate TPXOPER after it has been quiesced (CA TPX)?

book

Article ID: 11289

calendar_today

Updated On:

Products

TPX - Session Management Vman Session Management for z/OS

Issue/Introduction



If someone enters Q ALL from TPXOPER, this will quiesce all TPX applications including OPER.  How to reactivate TPXOPER after it has been quiesced?

Environment

CA TPX for z/OS

Resolution

There are three ways to enable TPXOPER after a QUIESCE has been initiated:

  1. If any user has not yet logged off TPXOPER, they will be able to activate it and any other desired applications:
    • ACT ALL or ACT applid 
  2. This console command can be used:
    • F TPX,ACT ALL
  3. If neither of the above is feasible, then cycling the TPX started task(s) will resolve the situation. The quiesce function is strictly a flag within the TPX storage. Once TPX is recycled it has a new address space and new storage.

 

Additional Information

For a complete description of the QUIESCE and ACTIVATE commands, please refer to the TPX 5.4 Session Management Operator Guide - Operating Commands.