search cancel

introscope.agent.weblogic.crossjvm default value

book

Article ID: 112606

calendar_today

Updated On:

Products

CA Application Performance Management Agent (APM / Wily / Introscope) INTROSCOPE

Issue/Introduction



Need to understand what is this below property in the IntroscopeAgent.profile ? Do we need to enable this on all the agents if we want to see cross jvm tracing? If so, why is this not enabled by default? ###################### # Cross JVM Tracing # ================ #The following property enables cross jvm tracing # You must restart the managed application before changes to this property take effect. #introscope.agent.weblogic.crossjvm=true

Environment

Release:
Component: APMISP

Resolution

Engineering team looked up the agent implementation for the introscope.agent.weblogic.crossjvm. It has the value false by default if it is not explicitly specified. Which means it is disabled. This is true and correct: When In agent profile: #introscope.agent.weblogic.crossjvm=true This means property is disabled (not enabled and false). In agent profile: introscope.agent.weblogic.crossjvm=true This means property is enabled and active. So, you must set this property to true in agent profile as follows: introscope.agent.weblogic.crossjvm=true