Are the username and password arguments required for the UIM probe utility ( pu.exe)?
book
Article ID: 112568
calendar_today
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
It is possible to put a UIM robot in maintenance mode with the probe utility (pu.exe), but can this be done without entering a username and password
Is it possible to execute probe utility (pu.exe) commands without entering a username and password?
Environment
UIM 8.51 and earlier
Resolution
No. A valid UIM username and password must be specified in order to execute probe utility (pu.exe) commands.
Probe utility usage:
pu.exe -u <UIM username> -p <username password> <UIM probe address> [probe command] [command data]
Feedback
thumb_up
Yes
thumb_down
No