ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
UIM Purestorage probe disk status incorrectly listed
Article ID: 112238
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
Getting alarms for disk(s) that are listed in a degraded state but looking at the Pure Storage UI, they are listed as OK.
Environment
Release:
Component: UIMPST
Component: UIMPST
Resolution
This has been observed when monitoring storage devices that had firmware version 4.8.10. Updating to firmware version 5.0.8 resolved the issue.
Feedback
Yes
No
Powered by
