ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
No output from SASSTRLR commands
book
Article ID: 111937
calendar_today
Updated On:
Products
CA 7 Workload Automation
Issue/Introduction
I ran a SASSTRLR program and did not get any responses/output from commands. Where is the output?
Environment
Release: Component: 7
Resolution
SASSTRLR is an external communicator that passes SPO0 commands to CA7. It does not get the response from processing the commands. If you would like to see the response or output from the commands, you should use the Batch Terminal Interface(BTI) or Common Communication Interface(CCI) external communicators.